Akai MPC 60 Manual do Operador descarregar pdf (Página 193)

Chapter 9: Saving and Loading From Disk

Page 187

============= SCSI Status ==============

Status:NO SCSI DEVICE IN USE

======= Make SCSI Device Active ========

SCSI device address to make active:AUTO

Timeout for SCSI scan:30

========================================

The fields and soft key are:

• The Status field:

This field shows whether a SCSI device is currently in use and if so, tells

the SCSI address of that device. There are eight possible SCSI

addresses, 0 - 7. Your external SCSI hard disk has a switch to select

one of these addresses. If a SCSI device is currently active, this field will

display the address of that device. It is a display field and cannot be

directly edited by the cursor. The 8 possible status messages are:

NO SCSI DEVICE IN USE

SCSI ID 0 IN USE

SCSI ID 1 IN USE

SCSI ID 2 IN USE

SCSI ID 3 IN USE

SCSI ID 4 IN USE

SCSI ID 5 IN USE

SCSI ID 6 IN USE

Only addresses 0 - 6 may be used for external SCSI devices. Address 7

cannot be used because it is the address of the MPC60.

• The SCSI device address to make active field:

This field determines which SCSI address will be scanned when the

power is turned on or when <Make active> is pressed. It is a choice field

with the following options:

AUTO (scan for lowest addressed SCSI device)

0 (scan for SCSI device address 0)

1 (scan for SCSI device address 1)

2 (scan for SCSI device address 2)

3 (scan for SCSI device address 3)

4 (scan for SCSI device address 4)

5 (scan for SCSI device address 5)

6 (scan for SCSI device address 6)

If only one SCSI device is connected to the SCSI port, select AUTO.

Then, when <Make active> is pressed or when power is turned on, the

single device will be made active regardless of its address setting, 0 - 6.

(If two or more devices are connected when the “AUTO” scan is done,

only the device with the lowest address will be made active.)

It is only necessary to enter a specific SCSI address (0 - 6) in this field if

more than one SCSI device is connected to the SCSI port. In this case,

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 240 241

Comentários a estes Manuais

Sem comentários

Akai MPC 60 Manual do Operador Página 193

Comentários a estes Manuais

Manuais e produtos relacionados com Sintetizador Akai MPC 60