Akai MPC4000 Manual de Serviço descarregar pdf (Página 34)

SERVICE MANUAL

! Installation – MPC4000

1. Remove the fixing screws of the MPC4000 Side Panels (4pcs. on each side) and remove Side Panels. Next,

remove the screws (5pcs. on each side) hidden by the Side Panels and then remove the center screws (2pcs.)

located underneath the Armrest and the topmost of Rear Panel. The Top Panel Block can be swing-opened by

lifting the Armrest from the front. Save the removed screws.

2. Remove the fixing screws (4pcs.) for the Mask Plate (upper slot) on the Rear Panel and remove the Mask Plate.

Save the screws for later use. The Mask Plate is not used.

3. Referring to the illustration, remove the fixing screw (1pc.) on the I/O board and install the Mounting Post (S) in

its place. Then extend the 2 Mounting Posts with the 2 Mounting Posts (L) included.

4. Set the IB-48P on the Rear Panel and Mounting Posts and fix it securely with the screws removed in earlier

step and the Fixing Screws (gold, 2pcs.) included.

5. Connect the cable from the IB-4ADT board to the connector (P4) on the I/O board.

6. Replace and fix the Top Panel Block and Side Panels in the opposite order to which they were removed.

Note 1: When the IB-48P 8-Individual Output board is installed at the lower slot, remove the fixing screws (2pcs.) of the

Mounting Posts for the IB-48P and re place them with the 2 Mounting Posts (L) included and mount the IB-4ADT on them.

Note 2: On the MPC4000 with IB-4D SP-DIF Digital Interface Board installed, Connect the 8-pin Connecting Cable

included between the IB-4D (P2) and IB-4ADT (P1) boards.

✽ Be sure to fix the screws and connectors securely to avoid malfunctioning.

PC IO

IB-4ADT

MPC4000

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Sem comentários

Akai MPC4000 Manual de Serviço Página 34