Akai S950 Manual do Utilizador descarregar pdf (Página 7)

Loading a Volume using the MIDI Program Change

Each volume number (V1-V128) is a match of a MIDI program change number

(1-128). You can select and load a desired volume by specifying the

corresponding MIDI program change number from an external MIDI master.

To do this, enter PAGE11 in the DISK mode.

Example: MIDI Program change number 9

MIDI program

change "9" +--------+ <- Volume 9 (V9) loaded +-------------+

-------------->| S950 |----------------------------| Hard Disk |

+--------+ +-------------+

This page must be open to enable this function.

Using the CD/DAT Interface Feature

For detailed information about this feature, see "REC MODE" in the S950

Operator's Manual.

Hints on digital sampling

Digital sampling using the IB-109 does not allow to adjust the REC LEVEL

(recording level). When an input level to the S950 is low: use the 'Digital Audio

Boost" feature (in Digital sampling using the IB-109, the MONITOR LEVEL

cannot be adjusted either) and raise the peak level to be close the the highest

level shown on the level meter in the S950 display.

+--------------------------------------+

| DIGITAL AUDIO BOOST |

| NO BOOST (1), +6dB (2), +12dB(3) |

+--------------------------------------+

In digital sampling, the "Pre-Trigger" feature will still work when a recording

(sampling) is started.

There will be a very short silence at the beginning of the sampled sound.

You should adjust the starting point of the playback in PAGE06 in the EDIT

SAMPLE mode. If this is not done, when you play the sampled sound, the attack

will seem delayed.

1 2 3 4 5 6 7 8 9

Sem comentários

Akai S950 Manual do Utilizador Página 7