Akai RE32 Manual do Operador descarregar pdf (Página 187)

Version 1.00 177

RS422

USING THE LAYBACK FUNCTION

The RE32’s IN and OUT markers set the record in/out points for the VTR. Assuming the functions

described above are set as appropriate, you must first press PREROLL

. You then press LAYBACK

and the VTR will drop in/out of record at the IN/OUT points marked.

You may ‘build’ the final transfer in sections (in this way, you can obtain the optimum mix section-

by-section) and set IN/OUT points as appropriate. You may rehearse the drop in/out using PRE-

VIEW and, when you’re happy with the results, press LAYBACK to actually ‘commit’ the recording

(in both instances, you must use PREROLL to locate to a time a bit before the IN point).

It may be that you want to transfer the whole project back to the video tape in one go. In this case,

set the IN at the start of the project and the OUT at the end of the project and press LAYBACK (F1/

F2) to transfer the whole project back to the master video tape in one pass.

Another use of this may be to receive a video tape as described above but the ‘sweetened’

version on the Akai system may be laid back to an RS422 equipped DAT machine thus preserv-

ing the dialogue on the original video with a synchronised ‘master’ on DAT.

4 The layback function will not work if the machine(s) are not located to a point before

the IN time. The layback function requires that there be some form of pre-roll.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192

Sem comentários

Akai RE32 Manual do Operador Página 187