Akai DPS16 Manual do Operador descarregar pdf (Página 126)

114

Chapter 10: Project Management (Project Mode)

Follow the steps below to write a Project to a CD-R/CD-RW disc.

➸

NOTE :

Before starting the steps below, check the Disk mode main screen to see if the DPS16 recognizes

the CD-R/CD-RW drive connected to the SCSI connector. (For more information on Disk mode, see page

125.) Also, insert a CD-R/CD-RW disc into the CD-R/CD-RW drive.

1. On the Project screen, select a Project to write onto the disc as the current Project.

2. Press the [F2] ( CD-R) key.

The following screen appears.

(x2)

1 Target project

Displays the name of the current Project.

2 Track to write L/R

Selects physical tracks (1-16) of the DPS16 you wish to write into the L/R channels of the disc.

3 Region ( IN-OUT/ALL)

Specify the region of the data you wish to write.

4 Write speed ( MAX/SLOW(x1)/FAST(x2)/x3/x4)

Specify the writing speed here. When MAX is selected, the fastest speed of the connected drive available

(within x1 to x4) will be used.

5 This area displays the information which is on the disc in the CD-R/CD-RW drive.

• Disc status (NOT FINISHED/FINISHED/NO DISC)

The Finish process is a process of writing readout information to a disc (see page 117). “ NOT FIN-

ISHED” appears if the Finish process has not been performed. “FINISHED” appears if the Finish process

has already been performed. “ NO DISC” appears if no disc is inserted in the drive.

• Total track ...... Displays the total number of tracks on the disc.

• Total time ........ Indicates the total time recorded on the disc.

• Free ....................... Indicates the time available on the disc.

6 Write length

Indicates the length of the actual recording data.

7 Test write (ON/OFF)

This field allows you to select whether or not to perform test writing (ON) before actually writing the data onto

the disc. (see “ Test write” on page 115)

3. Move the cursor to the Track to write L/R field (2) and set the DPS16 track numbers (1-16) to

be stored in the L/R channels of the disc.

• When you set the track numbers in the L/R fields, the track name specified in V.Track mode (see page 60)

appears on the right.

• If you wish to write mono data, select the same track number for the L and R channels.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 197 198

Sem comentários

Akai DPS16 Manual do Operador Página 126