Akai DR16 pro Manual do Operador descarregar pdf (Página 86)

9: Locate Functions

Page 77

Locate Functions

This chapter explains how to use the locate functions. You can locate to the beginning of a record-

ing. You can also locate to a specific point just by entering the time on the display, store and recall

up to nine direct locate points using the number keypad, and store and recall up to 100 stack

locate points. Unlike tape based recorders, the DR16pro does not need to rewind or fast forward

to locate specific points. DR16pro locate functions are instantaneous.

Locating to the Beginning of a Recording

To locate to the beginning of a recording:

1) Press the LOCATE key twice.

The DR16pro will immediately locate to the beginning of the recording.

Locating to a Specific Point

To locate to a specific point:

1) Press the LOCATE key.

You will see a display similar to the following:

ABS

2) Use the numeric keypad to enter the desired time.

Time values should be entered from left to right. For example, to enter the time 15 minutes

32 seconds 20 frames, press these numeric keys in the following order: 1, 5, 3, 2, 2, 0.

“- -:15:32:20” will appear on the display.

Note:

If you enter a time value that is greater than the possible range, the correct

position will be calculated. For example, if you enter 78 seconds, the DR16pro will locate

to 1:18.

If you make a mistake while entering the time, press the RESET key, then re-enter the time.

Press the ESCAPE key to cancel the locate function.

3) Press the LOCATE key.

The DR16pro will locate to the specified point.

Note:

Pressing the STORE/ENT key also causes the DR16pro to locate to the specified

point.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 166 167

Sem comentários

Akai DR16 pro Manual do Operador Página 86